sata186us version 3.1

This is a newer manual upgrade server software, also previously known
as "upgrade.exe"

Upgrade for ATA 186/188

NOTE: This software is to be run from dos command line
      in Windows 9X/ME/NT/2000

Requirements:
	-) network connection between PC and Cisco ATA 186 
	-) PC machine running windows O/S

----------------------------------------------------
To upgrade your box, save this executable and the software image
(the software image will have a ".zup" extension) and language 
image (the language image will have a ".kup" extension) in a 
directory on your PC.  At the DOS prompt of the directory where
the files are saved, you will enter the following:

	sata186us <software_file_name> -d1 -any2

WARNING -- When upgrading from software version 1.xx to 2.0, make
sure there are entries in the UID0 and UID1 fields, and that you 
hear a dial tone when you pick up the telephone handset.  Failure
to do so can result in loss of the MAC address during upgrade.

Your screen will prompt you with instructions on how to upgrade
the box.  You will access the voice prompt of the ATA 186 and 
enter the following commands:

	100#<ip_address_of_PC>*8000#
			(to upgrade the ATA 186's software version)

	101#<ip_address_of_PC>*8000#
			(to upgrade the ATA 186's language file)

When upgrading many boxes, you can save time by saving the commands
above in your telephone's speed-dial, and using them after accessing 
the ATA 186's voice menu.
----------------------------------------------------
Available options: when using this upgrade software:

usage: 

sata186us version 3.1
usage: sata186us {-h[host_ip]} {-p[port]} {-quiet} <imageFile>
	-h[host_ip]  Set host IP to specific IP (in the case where there
	               are more than one IP addresses for the host.
	               Default use 1st IP address obtained by gethostbyname).
	-p[port]     Set server port to specific port (default is 8000,
	               use different port only if you are setting up an IP
	               directed upgrade server other than the default).
	-quiet         quiet mode, send all output to log file named
	               as [port].log (useful when running the upgrade
	               server as a deamon).
	-any         Allow upgrade even if software version is less
	               than or equal to those of client box.
	-any2        Allow upgrade regardless of software type and version.
	-d1,-d2,-d3  Set verbose level for debugging.
	imageFile    Image file is file with a '.zup' or '.kup' extension.
e.g.
	sata186us -any -d1 test.zup
	sata186us -h192.168.2.170 -p8002 -quiet test.zup

----------------------------------------------------
Below is a sample run of upgrade server in ready mode
PC name: mypc
PC IP:   192.168.1.10
----------------------------------------------------
Microsoft(R) Windows Millennium
   (C)Copyright Microsoft Corp 1981-1999.

C:\>ata186us ata134-elang.kup
Using Host: mypc with IP : 192.168.1.10 as upgrade server
image found: language 51 -- ata186.itsp2.v1.34

Using dialpad of your telephone (attached to your ATA box),
press ATA button to go to main menu, and enter:

	101#192*168*1*10*8000#	(to upgrade language 51)

NOTE:
Pressing 123# will announce your code's version number.
You can later verify that you have upgraded your ATA box.

-------------------------------------------

This program runs continuously; Press <ctrl>-c to abort.
Upgrade server ready...